MATHEMATICAL MODELLING AND OPTIMIZATION OF MELON SLICE DRYING WITH RESPONSE SURFACE METHODOLOGY IN A HEAT PUMP DRYING SYSTEM

Optimization of melon slice drying

Authors

  • Cuneyt Tunckal Yalova University
  • Azime Ozkan Karabacak
  • Canan Ece Tamer Bursa Uludag University
  • Perihan Yolci Omeroglu Bursa Uludag University
  • Zekiye Goksel Atatürk Horticultural Research Institute

DOI:

https://doi.org/10.52292/j.laar.2022.851

Keywords:

Heat pump drying, Melon, Response surface methodology, Drying characteristics, Mathematical modelling

Abstract

The objective of this study was to optimize the process conditions (in terms of air temperature, air velocity and thickness of the slices) using response surface methodology (RSM) to achieve minimum specific energy consumption and maximum moisture diffusivity during drying of melon slices with a closed loop heat pump drying (HPD) system. An optimum drying temperature of 45 °C, air velocity of 1 m/s and slice thickness of 5.04 mm were recommended with following predicted responses close to experimental values: drying time 216.58 min, total energy consumption 2.94 kWh, coefficient of performance heat pump (COPhp) 3.08, coefficient of performance system (COPws) 2.75, specific moisture extraction rate (SMER) 0.22 kg/kWh, drying rate 2.53, L* value 82.53, a* value -1.83 and b* value 25.82. The most suitable models to represent the drying behavior of optimum melon slices was chosen Wang & Sing. Effective moisture diffusivities (Deff) of the melon slices were ranging from 7.075E-10 -  1.843E-07 m2s-1 and increasing drying air temperature, drying air velocity and slice thickness led to an increment of Deff.

Downloads

Published

2022-03-25

Issue

Vol. 52 No. 2 (2022): Latin American Applied Research

Section

Heat and Mass Transfer

License

Copyright (c) 2022 Latin American Applied Research - An international journal

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Once a paper is accepted for publication, the author is assumed to have transferred its copyright to the Publisher. The Publisher will not, however, put any limitation on the personal freedom of the author to use material from the paper in other publications. From September 2019 it is required that authors explicitly sign a copyright release form before their paper gets published. The Author Copyright Release form can be found here